If a Mechanical Golf Robot hits 10 shots using a New off the rack Driver averaging nearly an inch off center of the club face that would cause any golfer to have an erratic shot pattern, to say the least.īut, after spine aligning the shaft on the New Off the rack Driver, the Mechanical Golf Robot hits 10 shots averaging less than 0.1” off center of the club face.I go out of my way to order shafts that are inherently round to begin with thus reducing the impact of spine alignment. 0.7” (it looked like it had only hit one ball) 1.9” in diameterĢ) Using a New Off the rack Driver with shaft Spine Aligned:Īfter the 10 shots were recorded on the face of the driver there was an area on the impact sticker that measured approx. The mechanical golf robot was again used to hit 10 more balls at the same swing speed of 100 mph using a new impact sticker to record the shots on the clubface.ġ) Using the New Off the Rack Driver with the S haft “NOT” Spine Aligned:Īfter the 10 shots were recorded on the face of the Driver there was an area on the impact sticker that measured approx. The shot results were recorded on an impact sticker that was placed on the clubface of the driver.Ģ) Next the shaft was removed from the New Off the rack Driver head, Spine Aligned and reinstalled in the Driver head. This test involved using a Mechanical Golf Robot called Iron Byron to swing the driver.ġ) A New Off of the rack Driver was put in the Mechanical Golf Robot and tuned up properly to hit 10 golf balls with a swing speed of 100 mph. I was involved in testing the effects and differences of Spine Aligning versus not Spine Aligning, your golf shafts. This will cause the golfer to hit the ball more off-center than their swing might have otherwise ordained. If the spine effect is moderate to severe in the shaft, when the shaft bends in response to the golfer’s swing force, the direction of bending of the shaft can move off the direction of bending, thus shifting the position of the club and clubface. You now have the only two positive areas of the Golf Shaft.Īll golfers put a bending force on the shaft at some point during the downswing. We are ISOLATING the Spine so it is no longer a factor in the flex of the golf shaft. By decreasing the shaft’s movement in directions other than the final swing plane, Club Makers, can reduce shaft-induced miss hits by stabilizing the shafts torsional stiffness for more distance, accuracy and all around better shaft performance.Īs Club Maker’s, we find the Spine of the shaft and place it into the club head, with the Spine Towards or Away from the target. Thus, the shaft unloads or kicks forward during the golf swing. When a shaft’s most predominant Spine is properly aligned in a neutral position, the shaft bends along the Principle Planar Oscillation Plane, the longitudinal plane of bending through which a shaft can move as closely as possible to a perfect straight line with no movement in any other direction. Spine orientation, or spine aligning, the new process which measures a shaft under both constant and dynamic load to precisely locate shaft inconsistencies in the shaft wall thickness, shaft straightness, shaft roundness and shaft material. The Physics of Spine Aligning (The Scientific Explanation) By Spine Aligning your shaft the clubface will open and close when you want it to, not when the shaft wants it to. The simple and easy way to explain Spine Aligning is finding the natural bending position of the golf shaft, which is the least point of resistance.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |